Could something have shaken loose during the 20 miles we trailered this machine? Please help. Is there anything electrical that would cause this? I noticed a wire going to the injector and disconnected it at a quick connector and the machine would not start at all. If I leave it sit for even 30 seconds or more, it will start and run 3-4 seconds. If I try to restart it immediately after it quits, it will restart, but run a bit shorter on time. Always same result: start fine, run 3-4 seconds, quit. I have cracked open the injector lines at the top of the engine, have checked to see if there is sufficient fuel supply to the fuel pump, and have tried to run it on quite a few different days and quite a few times each try. Now it consistently starts no problem, and at any throttle setting, but it only runs for 3-4 seconds and then stops. We have since installed a new fuel filter, bled the fuel filter housing at the top, and have cleaned and checked air intake filters, all ok. Using either, we could get it to run, but not stay running. It would not start when we went to unload it. It restarted, ran fine, got loaded onto trailer. Looked like it was out of fuel, so we added a few gallons (Diesel). We started to move it to a new location when just before loading, it quit. This machine was used very little in previous years.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |